PileHouse is starting to shape up and we can now envision what the truck will someday look like when it’s “done”. But I still felt that the front end needed “something more”. After staring at it over lunch one day, I decided that the truck needed a custom bumper to “complete” the front end. My only rules were that it had to flow with the grill trim and relatively flat front end. So I took some measurements, snapped a few reference pictures with my Iphone, and headed off to one of my favorite places; the New Ringgold U-Pull-It junkyard. This place is HUGE and they’re nice enough to drop all of the “classic” cars and trucks in one section where you can rummage around. It’s there you’ll find everything from a 40′s Ford to an El Camino or even obscure European classics like a Renault LeCar. This place is a hotrodders dream! All you need is a battery powered reciprocating saw, some hand tools, a tape measure, and a good imagination to find parts for your custom project.
So I set off with my bag filled with Eastwood Hand Tools and the portable reciprocating saw in hand. After a couple hours measuring bumpers, and scratching our heads, my buddy Matt R. and I narrowed it down to two vehicles. Eventually we chose the front bumper off a 60′s Chevy Corvair van (obscure enough for you?!). The length and shape was pretty darn close to the stainless grill trim on PileHouse, and I was sure I could make it work. We quickly got down to business and cut the bumper off so I could bring it home.
With bumper and truck meeting for the first time, I can see that although the size was “close”, the bumper was still going to need a few inches chopped off, and the radius changed to match the front of the truck.
I started by marking the corners of the bumper where I wanted them to sit and noted some measurements of the bumper and the front end while on the truck to give me some reference points throughout the project. Next I pulled out the angle grinder and cut the bumper in half in the center, and laid it back in place.
After test fitting the bumper halves, I overlapped them in the center to give me an idea of what had to be removed to get the bumper to the correct length. Once I cut the excess off I found an additional cut had to be made to allow the bumper halves to lay back to match the curve of the front end. With this last cut made, they were sitting exactly how I wanted and I spot welded them in place until I could join them together. Finally, I welded some small strips of metal in place to join the halves temporarily.
With the bumper now shaped to fit the front end of PileHouse, I removed the tack welds on the corners and put the bumper on the work bench to add braces to the backside and ground off the temporary front braces. Next I had to fill the opening that was created when the radius was changed. I found that the last piece I cut off was a good fit after a little sanding. With the filler metal set in place, I began welding it all together with the Eastwood MIG 175. After welding the seams up on both sides I took the angle grinder with a flap disc and blended the welds. A few minutes of grinding I had a smooth, invisible transition where I had modified the bumper.
With a complete front bumper bar, I test fit it one more time. I’m happy to report I now have a bumper that fits perfectly and I’m only out about $30 and a few hours of work! From here I’ll fabricate some simple bumper mounts to bolt it to the chassis, and then we can move on to the next step in making PileHouse road worthy!